Total 0,2 l

Home use: 200-250 ml/10 l water.

For seed-sprouting weeds, apply at the lower dose specified in the authorisation document. For seed-borne dicotyledonous weeds, treatment should be carried out at 4 to 8 true leaf phenology, for seed-borne monocotyledonous weeds at 3 to 5 leaf stage.
In the case of perennial dicotyledonous and perennial monocotyledonous weeds, the preparation should be applied at the intensive growth stage to ensure that the active substance is also released into the underground reproductive formations of the weed.
For tarack wheat, pine nutsedge and reed canary grass, the most beneficial effect is obtained in autumn when the nutrient flow to the rhizomes is most intense. The optimum time for treatment is at flowering for sulphur-leaved plants and at the time when the leaves are in the bud for field acacia.
Considering the meteorological conditions, glyphosate is most effective between 15-25 "C and high humidity. To be effective, it is important that no precipitation occurs within 6 hours of treatment to allow the active ingredient to be fully absorbed by the weed
The product is non-selective and the active substance must not be applied to the crop to be protected from weeds, as it may damage the crop.
May be used:
In arable crops, before or after sowing until germination, when the sown seeds are covered with a layer of fine crumbs at least 3 cm thick. This technology cannot be used on soils with less than 3 % organic matter.
For the treatment of perennial weeds after they have been ploughed up to 15-30 cm. Tillage should be carried out shallowly, in such a way that the stubble is broken up and the dormant buds are removed.
Non-agricultural areas: roads, road embankments, drainage ditches in impervious condition, industrial installations, petrol stations, airports, railway lines, total weed control where not prohibited by local regulations.

Total weed control in residential areas, small gardens, cemeteries, where not prohibited by local ordinance
Weed control of unlined canals, ditch banks against reeds, rushes and other perennial weeds which are difficult to control.
Weed control of pasture and grassland when renovating pasture and grassland prior to breaking up or reseeding.
In lucerne, in the form of spot treatment or complete surface treatment in areas heavily infested with alfalfa. For spot treatment, use at a concentration of 0,2-0,3 %. For complete surface treatment, the dose is 0,5-0,7 l/ha. The treatment may slightly retard alfalfa head shoots until the next mowing, therefore full surface treatment is only recommended in heavily infested areas. Treatment should be applied 5-7 days after mowing through the alfalfa. It is not recommended for use in seed-bearing alfalfa or at the seed set stage.
In forestry crops, it may be used for weed and shrub control on any tree species prior to afforestation. After felling, use at a concentration of 3,5 % against stump borers.
For forestry weed control only in spruce, Scots pine and cork pine plantations older than two years. For the protection of pine plantations, the product may be applied when a protective wax layer has formed on the needles.
In vineyards and fruit orchards: table grapes, wine grapes, apple (apple, pear, quince, pear), stone fruit (cherry, sour cherry, peach, nectarine, apricot, currant, plum) and nuts (walnut, almond, hazelnut, chestnut).
It should only be applied in plantations older than 3 years, using a sprayer with a protective disk or other special spraying technique. Treatment should be carried out in spring until the shoots start to grow or in autumn after fruit harvest. If the weed cover warrants, treatment can be carried out between the two dates, with increased precaution. Care should be taken during application not to get the spray on the green parts of the crop (shoots, leaves) as this will cause permanent damage. Seedlings less than 3 years old, which have not yet atrophied, will also be damaged by the active substance.
Stand drying in sunflower, rape, maize, soybean crops:
Apply at the lower dose for the crop in weedy stands and the higher dose in weedy areas
The treatment should be carried out at 20-30 % grain moisture in sunflower and 30-40 % grain moisture in maize.
In rape, treatment should be applied when at least 60 % of the seeds in the middle third of the beet level are brown, the beet being still green.
In soya beans, the pods may be applied after yellow-yellowish-brown discolouration, when the moisture content of the soya bean seeds is around 30 %.
In rape and soya, application may be made exclusively by field machinery (bridge tractor). Its use in seed production is not recommended.
In winter wheat and winter and spring barley, for pre-harvest weed control to facilitate harvesting, the product should be applied by field machinery only, mainly on areas heavily infested with perennial weeds (tarack wheat, reeds, river cane, etc.), at least 14 days before the planned harvest.

Aerial application: only in sunflower and maize, with a minimum of 10 ha of contiguous field size, with the obligatory addition of a spray drift inhibiting additive and the use of an anti-drift nozzle. For aerial application, the requirements laid down in the joint FVM-GKM-KvVM Decree No 44/2005 (6.V.2005) must be fully complied with.

Application rate: 50-60 l/ha
Application by hydraulic tractor: application by ground machine with a high ground clearance (> 150 cm) only with the addition of a drift inhibiting additive.