Classic irrigation control 6030

The GARDENA Classic Irrigation Control 6030 is intended for the control of larger, usually recessed irrigation systems such as the GARDENA Sprinklersystem. The Classic Irrigation Control 6030 is ideal when the water volume is not sufficient to operate the entire system (usually consisting of several irrigation systems) at the same time. The device operates with different watering durations per irrigation circuit according to the different water requirements of each area, allowing individual, optimum irrigation. Up to six 24 V irrigation valves (part number 1278-20) can be connected to the Classic 6030 Irrigation Controller. Up to three different programs per valve can be programmed for flexible irrigation programming. Watering days and cycles can be individually selected, watering times from 1 minute to 3 hours 59 minutes can be set and can be adjusted centrally in the range 0-200%. With manual control, irrigation can be switched on immediately. Programming is simple and intuitive thanks to the large, easy-to-read display, which also shows instructions. A GARDENA Pump Relay (Art. No. 1273-20) can be connected via the main hose to control one pump as an alternative water source. The GARDENA Classic Irrigation Control 6030 requires a 230 V supply voltage and can be used indoors, e.g. in garages or in rain-protected areas. In order to ensure that the Irrigation Control always works reliably and safely, a 9 V alkaline battery (not included) provides protection against power failure. For water-saving operation, a GARDENA Soil Moisture and Rain Sensor can be connected.